Fibery Goodness Module Three Yarn

Mod 3 yarn. Hmmmm… What can I say? I was on a roll and spun up mod 2 and rolled right into Mod 3. Module 2 was about Trials and Tribulations but I swear Mod 3 should have been the trials and tribulations!!

Mod 3 Yarn Attempt 1 and 2

I was going for a gimp spiral yarn as on page 118 of the Spinners book of yarn designs by Sarah Anderson. Did I succeed? You tell me.

 

Same commercial prep combed top 15.5 micron merino. Pure white. Yarn on left is first attempt. Yarn on right second attempt.

 

I spun a super fine single. More fine than I have ever done in my life. Probably not terribly even and too much twist as I wasn’t even in the ballpark of comfort zone!! Spun a bobbin of single that was supposed to be twice as thick probably was more like 3-4 times. Had way too much twist in it. Bobbin wasn’t taking up properly. Thought it might be OK when I plied.

Mod 3 Yarn Attempt 1 and 2

Tried plying on my new CS2. Didn’t go well. Came off bobbin like a rubber band hung around the door knob and snapping back in your face!! That’s the left yarn. It seems like a cross between a super coil and a core spun and an angry rubber band. And it feel like I spun it out of a Brillo pad. Looks cool. Not even close to what I was going for.

 

Attempt 2: When my big single bobbin ran out, my thin single bobbin was still half there so went and spun up a new thick single with very little twist in it but again probably a whole lot more than just half bigger than thin one. Tried to keep it even. I plied on my CS2 again. Got half way through the 2 bobbins when I realized I was plying to the right the same way both singles had been spun. Crap!!! Cut the yarn and wound off bobbin back onto my left hand until I got to beginning. Had a lot there and being over energized it was tight as well as unruly. Thought if I just started it back at beginning and doubled plyed to left it would untwist the wrong bit and re twist it up right. It did. Sort of. Tangled it in knots. Had yarn everywhere. Had hubby waiting on me to do something but me not able to put ti down as it was a tangled mess on my left hand when trying to re ply and untangle with both hands at same time. I obviously didn’t think this one through!!! Eventually got it sorted. Than joined on with the last half of bobbins, join didn’t take the best so will have to be careful of that bit when I weave with it but got it going.

Mod 3 Yarn Attempt 1 and 2 Close Up

 

It is easy enough to do when you do it right from the start!!! I believe it is a nice soft relatively even medium weight spiral, but is it a gimp spiral???

 

I do love my second version even if it is not a gimp spiral yarn and may have a new best favorite yarn. Thoughts??

Leave a Reply